Difference between revisions of "Updating from 2.x to 3.x Firmware"

From berofix - professional SIP gateway
Jump to: navigation, search
(Update Procedure)
(Update Procedure)
Line 17: Line 17:
 
* Backup your gateway configuration (Management->Backup and Restore)
 
* Backup your gateway configuration (Management->Backup and Restore)
 
* Reboot the gateway
 
* Reboot the gateway
* Update to the new 3.0 Firmware (Management->Firmware Update)
+
* Update to the new [http://www.beronet.com/wp-content/uploads/downloads/berofix/appfs-3.0.10.tar.gz 3.0.10] Firmware (Management->Firmware Update)
 
* Perfom a factory reset (Management->Reboot/Reset)
 
* Perfom a factory reset (Management->Reboot/Reset)
 
* Restore your gateway configuration (Management->Backup and Restore)
 
* Restore your gateway configuration (Management->Backup and Restore)

Revision as of 13:27, 2 June 2016

Update Procedure

Important, please read before updating!


IF YOU USE A FIRMWARE LOWER THAN VERSION 2.3sp3 IT'S STRONGLY RECOMMENDED TO UPDATE TO FIRMWARE VERSION 2.3sp3 FIRST.

IMPORTANT NOTE: DON'T install the 3.0 Firmware in the recovery Mode of the hardware factory reset when you come from a 2.x Version!!!

Please note the gateways use DHCP per default in V3!

Since substantial changes have been made between the 2.3 Firmware and the new 3.0 Firmware, the update process needs a little more attention than usual.

To perform a successful update and to keep your current configuration intact, it is strongly recommended to perform the following steps:

  • First of all update to 2.3sp3 version
  • Backup your gateway configuration (Management->Backup and Restore)
  • Reboot the gateway
  • Update to the new 3.0.10 Firmware (Management->Firmware Update)
  • Perfom a factory reset (Management->Reboot/Reset)
  • Restore your gateway configuration (Management->Backup and Restore)


The gateway may not be in a fully functioning state until the factory reset has been performed.


The current stable 3.0 firmware can be downloaded here: 3.0.10.


The changelog can be viewed here: http://wiki.beronet.com/index.php/Releasenotes#3.0_STABLE_-_Firmware