Difference between revisions of "Howto Hardware Factory Reset"

From berofix - professional SIP gateway
Jump to: navigation, search
Line 13: Line 13:
  
 
*4. In case of a Box Power up the device or in case of a card plug the card in your computer and power up the device.
 
*4. In case of a Box Power up the device or in case of a card plug the card in your computer and power up the device.
*5. After you power up the device the berofix should be reachable again with the default IP address 10.0.0.2. Open your Browser with this new address and wait until you get a response from the berofix (this could take a couple of minutes. see picture below).
+
*5. After you power up the device the berofix should be reachable again with the default IP address 10.0.0.2. or a new IP-address. Open your Browser with the address and wait until you get a response from the berofix (this could take a couple of minutes. see picture below).
 
[[Image:Bf_HWReset2.png]]
 
[[Image:Bf_HWReset2.png]]
 
*6. Upload a new Firmware (see picture above).
 
*6. Upload a new Firmware (see picture above).

Revision as of 12:44, 25 April 2016

This Howto describes how to do a factory reset on a berofix device. This could be useful in case of a lost password or in any case where you lost the connection to the berofix device. This Feature works only with Firmware Version > 1.12 and FPGA image Version >= 3. The Hardware Factory Reset deletes all data on the berofix device incl. the firmware and restores the default values. There are 8 steps howto initiate the Hardware Factory Reset.

  • 1. Power off the card/device.
  • 2. In case of a card remove the card from your computer. In case of a Box check if you can access the PCM connector on the rear from the outside, otherwise open the box.
  • 3. Card:Short the two pins horizontal with a jumper ( the yellow marked rectangle see Picture below). Box: Short the two pins vertically with a jumper (the yellow marked rectangle see Picture below)
Bf HWReset1.png PCM Hardware.png


  • 4. In case of a Box Power up the device or in case of a card plug the card in your computer and power up the device.
  • 5. After you power up the device the berofix should be reachable again with the default IP address 10.0.0.2. or a new IP-address. Open your Browser with the address and wait until you get a response from the berofix (this could take a couple of minutes. see picture below).

Bf HWReset2.png

  • 6. Upload a new Firmware (see picture above).
  • 7. Install the new Firmware (see picture below).

Bf HWReset3.png

  • 7. Power Down the device and remove the Jumper.
  • 8. Power Up the device. The device is now Ready with factory defaults.